Multichannel-systems STG-Lite Manual Bedienungsanleitung

STG-Lite Manual

STG-Lite Manual 6 3.3 Setting Up and Connecting the STG Note: You can use a USB hub for connecting the STG to the computer, for example, if you have

Installation 7 Illustration of the STG 2000 series rear panel and connectors Rear panel of the upgraded STG version (from 1000 series to 2000)

STG-Lite Manual 8 Illustration of the STG 4000 series rear panel and connectors

9 4 Use of STG-Lite 4.1 Welcome to STG-Lite The STG-Lite software program connects to the stimulus generator via USB (2.0 High Speed) cable. Change

STG-Lite Manual 10 STG: Serial number. Drop down list of connected STG devices if more than one stimulus generator are connected. Please choose the ac

Use of STG-Lite 11 Stimulation patterns: You can choose weather you want to stimulate via waves or via pulses. The main menu changes accordingly.

STG-Lite Manual 12 Info: The dialog shows basic information about the STG-Lite software and about the connected stimulus generator STG. Note: Please k

Use of STG-Lite 13 4.2 Stimulation Pattern: Waves Select stimulation pattern "Wave". The main menu with default settings appears. Channel

STG-Lite Manual 14 Frequency The waves can be delivered in a frequency between 0.1 and 10000 Hz. Click 1, 10, 100 or 1000 Hz as a basic value. Fine t

Use of STG-Lite 15 4.3 Stimulation Pattern: Pulse Select stimulation pattern "Pulses". The main menu with default settings appears. Chann

Information in this document is subject to change without notice. No part of this document may be reproduced or transmitted without the express w

STG-Lite Manual 16 Amplitude Select the amplitude of the pulse. The unit is millivolt (mV). Click onto the red point of the control dial and move it

Use of STG-Lite 17 A classic theta burst consists of four pulses at 100 Hz, repeated ten times with intervals of 200 ms, for example. Digital Sync O

19 5 Troubleshooting 5.1 Error Messages Firmware Update STG-Lite needs a firmware update. If you do not have the adapted firmware an error message w

21 6 Index

STG-Lite Manual 22 A Amplitude 14 Amplitude and DC Offset 12 E Error message 17 Firmware update...17 F Frequency 12 I In

23

iii Table of Contents Introduction 1 Introduction 1 Important Safety Advices 3 Guarantee and Liability 3 Operator's Obligations 3 Important

1 1 Introduction 1.1 Introduction The software STG-Lite is supposed to be an alternative to the default program MC_Stimulus II for the control of the

3 2 Important Safety Advices 2.1 Guarantee and Liability The General conditions of sale and delivery of Multi Channel Systems MCS GmbH always apply.

STG-Lite Manual 4 2.4 Important Safety Advice Warning: Make sure to read the following advice prior to install or to use the device and the software

5 3 Installation 3.1 System Requirements System requirements Software: One of the following Microsoft Windows ® operating systems is required: Windo